This setting lets you enable the critical output of the fleet controller when a critical event happens. These events are:

• An unexpected answer on critical question during checklist.
• Excessive idling, vehicle is not moving for a set period and no one is on the seat.
• Critical impact or collision of any sort that met or exceeded the critical set value in Gs.

1. From the menu on the ribbon bar, click ADMINISTRATION and then Critical Output.
2. Locate the category to edit and click .
3. Tick the checkbox on "Enable Critical Ouput" to enable, read and understand RCT's safety notice, tick the checkbox at the end and take necessary safety precautions.
4. Tick off "Enable Critical Ouput" to disable critical output, remaining settings are dimmed and cannot be set, proceed to step 8.
5. Select "Output Delay" setting from dropdown list with pre-set of 5, 10, 60, 120, 180 or 240 seconds. This is the delay time before the critical output turns ON. A countdown timer will be shown on the fleet controller's display.
6. Select "Buzzer Duration" setting from dropdown list with pre-set of 1, 2, 3, 5, 10, 15 or 25 seconds. This is the duration of the audible buzzer on the fleet controller's display when critical event occur.
7. Select "Output Period" setting from dropdown list with pre-set values below. This is how long the critical output will be engaged and get turned off.
   1. 5 sec or IGN OFF
   2. 10 sec or IGN OFF
   3. 60 sec or IGN OFF
   4. 10min or RESET by Supervisor
   5. 1 hr or RESET by Supervisor
   6. 4 hr or RESET by Supervisor
   7. 8 hr or RESET by Supervisor
   8. Until reset by Supervisor
8. Click .

Notes on Operation

• The Critical Output will turn on without delay when a critical checklist question is failed.
• The buzzer will always sound for 15 seconds just before the Critical Output turns on.